Dell POWEREDGE M1000E - Manual (Page 713)

Configuring IP Multicast 711
SSM Range Configuration
Use this page to display or remove the the Source Specific Multicast (SSM) group IP address and group
mask for the PIM router.
To display the page, click IPv4 Multicast > PIM > SSM Range Configuration or IPv6 Multicast >
PIM > SSM Candidate Configuration.
Figure 12-42. SSM Range Configuration
The SSM Range Configuration page contains the following fields:
• SSM Group Address — Displays the Source-Specific Multicast (SSM) group IP address.
•
SSM Group Mask — (IPv4) Displays the SSM group ip-address mask.
• SSM Prefix Length — (IPv6) Displays the source-specific multicast group Prefix Length.
• Remove — Select this option and click Apply Changes to remove the specified SSM Group IP
Addresses for the PIM router.
To configure the SSM Range, click the Add button to display the SSM Range Configuration page. Enter
values for the SSM Group Address and SSM Group Mask, click Apply Changes, then the Back button.
Configuring the BSR Candidate using the CLI Commands
For information about the CLI commands that perform this function, see the following chapter in the
CLI Reference Guide:
• PIM Commands