Dell POWEREDGE M1000E - Manual (Page 514)

512 Configuring Routing
RIP Interface Configuration
Use the RIP Interface Configuration page to enable and configure or to disable RIP on a specific
interface.
To display the page, click Routing > RIP > Interface Configuration in the tree view.
Figure 9-30. RIP Interface Configuration
The RIP Interface Configuration page contains the following fields:
• Interface — Select the interface for which data is to be configured from the drop-down menu.
•
Send Version — RIP Version that router sends with its routing updates. The default is RIP-2. Possible
values are:
–
RIP-1 — send RIP version 1 formatted packets through broadcast.
– RIP-1c — RIP version 1 compatibility mode. Send RIP version 2 formatted packets through
broadcast.
– RIP-2 — send RIP version 2 packets using multicast.
– None — no RIP control packets are sent.
• Receive Version — RIP Version of the routing updates that the router must accept. The default is
Both. Possible values are:
–
RIP-1 — accept only RIP version 1 formatted packets.