Dell POWEREDGE M1000E - Manual (Page 341)

Configuring Switching Information 339
Removing a MAC - IP Subnet Entry
1. Open the Bind IP Subnet to VLAN page.
2. Click Show All.
The IP Subnet - VLAN Bind Table displays.
3. Check Remove for each entry to remove.
4. Click Apply Changes.
The entry/entries are removed, and the device is updated.
Binding IP Subnets to VLANs Using CLI Commands
For information about the CLI commands that perform this function, see the following chapter in the
CLI Reference Guide :
• VLAN Commands
Protocol Group
In a protocol-based VLAN, traffic is bridged through specified ports based on the VLAN’s protocol. User-
defined packet filters determine if a particular packet belongs to a particular VLAN. Protocol-based
VLANs are most often used in situations where network segments contain hosts running multiple
protocols.
Use the Protocol Group page to configure which EtherTypes go to which VLANs, and then enable
certain ports to use these settings.
To display the Protocol Group page, click Switching > VLAN > Protocol Group in the tree view.