Dell POWEREDGE M1000E - Manual (Page 351)

Configuring Switching Information 349
Displaying the LACP Parameters Table
1. Open the LACP Parameters page.
2. Click Show All.
The LACP Parameters Table displays.
Figure 7-69. LACP Parameters Table
3. Use the Unit drop-down menu to view the LACP Parameters Table for other units in the stack, if they
exist.
Modifying LACP Parameters for Multiple Ports
1. Open the LACP Parameters page.
2. Click Show All.
The LACP Parameters Table displays.
3. Click Edit for each Port to modify.
4. Edit the fields as needed.
5. Click Apply Changes.
The LACP Parameter settings are modified, and the device is updated.
Configuring LACP Parameters Using CLI Commands
For information about the CLI commands that perform this function, see the following chapter in the
CLI Reference Guide :
• LACP Commands
LAG Membership
Your switch supports 48 LAGs per system, and eight ports per LAG. Use the LAG Membership page to
assign ports to LAGs and LACPs.