Dell POWEREDGE M1000E - Manual (Page 373)

Configuring Switching Information 371
The MLD Snooping General page contains the following fields:
• Interface — Specifies the Unit and Port or the LAG on which MLD Snooping should be enabled.
• Auto Learn — Enable or Disable the ability of the switch to automatically learn about dynamic MLD
ports.
• Host Timeout — Specifies time (in seconds) before an MLD snooping entry is aged out. The range is
from 2 to 3600 seconds. The default time is 260 seconds.
• Multicast Router Timeout — Specifies time (in seconds) before aging out a Multicast router entry.
The range is 1 to 3600 seconds. The default value is 300 seconds.
• Leave Timeout — Specifies the amount of time (in seconds) after a port leave message is received
before the entry is aged out. Enter value for the timeout period, or click Immediate Leave to specify an
immediate timeout. The range is from 1 to 3599 seconds. The default timeout is 10 seconds.
Displaying the MLD Snooping Table
1. Open the MLD Snooping General page.
2. Click Show All.
The MLD Snooping Table displays.
Figure 7-87. MLD Snooping Table
Copying MLD Snooping Settings to Multiple Ports, LAGs, or VLANs
1. Open the General MLD snooping page.
2. Click Show All.
The MLD Snooping Table displays.
3. Click Copy Parameters From.
4. Select a Unit/Port, LAG, or VLAN to use as the source of the desired parameters.
5. Click Copy To for the Unit/Ports, LAGs, or VLANs that these parameters will be copied to.
6. Click Apply Changes.
The MLD Snooping settings are modified, and the device is updated.