Dell POWEREDGE M1000E - Manual (Page 186)

184 Configuring System Information
Configuring the Telnet Server Using CLI Commands
For information about the CLI commands that perform this function, see the following chapter in the
CLI Reference Guide :
• Telnet Server Commands
Denial of Service
Denial of Service refers to the exploitation of a variety of vulnerabilities which would interrupt the
service of a host or make a network unstable. Use the Denial of Service page to configure settings to help
prevent denial of service attacks.
To display the Denial of Service page, click System > Management Security > Denial of Service in the
tree view.
Figure 6-67. Denial of Service
The Denial of Service page contains the following fields:
• Denial of Service SIP=DIP — Enabling SIP=DIP DoS prevention causes the switch to drop packets
that have a source IP address equal to the destination IP address.
• Denial of Service First Fragment — Enabling First Fragment DoS prevention causes the switch to
drop packets that have a TCP header smaller than the configured minimum TCP header size (Min
TCP Hdr Size).