Dell POWEREDGE M1000E - Manual (Page 318)

316 Configuring Switching Information
Figure 7-42. STP LAG Table
3. To change the STP settings for one or more LAGs, select the Edit option for the LAG(s), configure the
desired settings, and then click Apply Changes.
Defining STP LAG Settings Using CLI Commands
For information about the CLI commands that perform this function, see the following chapter in the
CLI Reference Guide :
• Spanning Tree Commands
Rapid Spanning Tree
Rapid Spanning Tree Protocol (RSTP) detects and uses network topologies that allow a faster
convergence of the spanning tree without creating forwarding loops.
To display the Rapid Spanning Tree page, click Switching > Spanning Tree > Rapid Spanning Tree in
the tree view.
Figure 7-43. Rapid Spanning Tree
The Rapid Spanning Tree page contains the following fields:
• Interface — Determines if RSTP is enabled on a Unit/Port or on a LAG. Click Unit/Port or LAG to
specify the type of interface, then select the Unit/Port or LAG to configure from the drop-down menu.
• State — Displays the spanning tree state for the port.