Dell POWEREDGE M1000E - Manual (Page 335)

Configuring Switching Information 333
Assigning Ports to VLAN Groups Using CLI Commands
For information about the CLI commands that perform this function, see the following chapter in the
CLI Reference Guide :
• VLAN Commands
VLAN LAG Settings
Use the VLAN LAG Settings page to map a LAG to a VLAN. Untagged packets entering the switch are
tagged with the LAGs ID specified by the PVID.
To display the VLAN LAG Settings page, click Switching > VLAN > LAG Settings in the tree view.
Figure 7-56. VLAN LAG Settings
The VLAN LAG Settings page contains the following fields:
• LAG — Specifies the LAG number included in the VLAN.
•
Port VLAN Mode — Indicates the Port VLAN mode for the LAG. Possible values are:
–
General — The LAG belongs to VLANs, and each VLAN is user-defined as tagged or untagged
(full 802.1Q mode).
– Access — The LAG belongs to a single, untagged VLAN.
• Trunk — The LAG belongs to more than one VLAN, and all ports are tagged (except for an optional
single native VLAN).
• PVID (1–4093)| 4095 — Assigns a VLAN ID to untagged packets. The possible field values are
1–4093 or 4095.
• Frame Type — Specifies packet type accepted by the LAG. Admit Tag Only is the default. Possible
values are: