Dell POWEREDGE M1000E - Manual (Page 718)

716 Configuring IP Multicast
Figure 12-46. PIM-SM Global Configuration
The PIM-SM Global Configuration page contains the following fields:
• Admin Mode — Select Enable or Disable from the drop-down menu to set the administrative status
of PIM-SM on the system. You must enable IGMP before enabling PIM-SM. The default is Disable.
• Join/Prune Interval (secs) — Enter the interval between the transmission of PIM-SM Join/Prune
messages. The valid values are from 10 to 3600 secs. The default value is 60.
• Data Threshold Rate (Kbps) — Enter the minimum source data rate in K bits/second above which the
last-hop router switches to a source-specific shortest path tree. The valid values are from 0 to 2000 K
bits/sec. The default value is 50.
• Register Threshold Rate (Kbps) — Enter the minimum source data rate in K bits/second above which
the Rendezvous Point router switches to a source-specific shortest path tree. The valid values are from
0 to 2000 K bits/sec. The default value is 50.
Configuring PIM-SM
1. Open the PIM-SM Global Configuration page.
2. Set Admin Mode to Enable or Disable, to turn PIM-SM on or off.
3. Modify the remaining fields as needed.
4. Click Apply Changes.