Rockwell Automation 441-PEN25 Enpac Ex Data Collector - Manual (Page 31)

Publication GMSI00-UM001A-EN-E - February 2005
The Enpac Ex 25
2. Tap Cont. - to lighten the display. Tap Cont. + to darken the display.
Repeat by pressing Shift and tapping the Cont. button again until the
display is adjusted properly.
Rebooting the Enpac Ex
You should reboot the Enpac Ex if the instrument locks up and does not
respond to any key presses including the ON/OFF key.
1. Press the 7, 8, 9, and 2 keys simultaneously. A confirmation window
appears.
2. Tap the Yes button to reboot the Enpac Ex.
Rebooting the Enpac Ex will require the date and time to be re-entered. See
Setting the Date, Time, and Date Format on page 22.
Hardware Reset
WARNING
Do not perform a hardware reset unless the area is known
to be nonhazardous.
ATTENTION
Do not remove the battery access panel unless the Enpac
Ex has been powered off.