Rockwell Automation 441-PEN25 Enpac Ex Data Collector - Manual (Page 12)

Publication GMSI00-UM001A-EN-E - February 2005
6 The Enpac Ex
Certification and Operation The Enpac Ex has been certified for use only with the following
accelerometers and accessories. Any attempt to use any other equipment will
render the instrument’s certification permanently invalid.
For operation in hazardous areas, the Enpac Ex and the approved accessories
(see Table 2.1) must be used. See the Enpac Ex Safety Instruction Sheet (on the
Enpac Ex Op-sys and Documentation CD) for safety instructions and
connector parameters. The Enpac Ex Op-sys and Documentation CD is
packaged with the Enpac Ex.
Cleaning
Use a damp, clean cloth for cleaning. Do not use cleaning fluids, abrasives, or
aerosols, as these substances may harm the finish of the instrument.
Table 2.1 Enpac Ex Accessories
Instrument Part Number
Accelerometer EK-48623
EK-48620
Cables EK-48626
EK-48634
Power Supply (PSU-7) EK-48624
Magnetic Mount EK-48629
Soft Case EK-48630
WARNING
• Substitution of components may impair suitability for
hazardous locations.
• Do not power the Enpac Ex using the external DC
supply unless the area is known to be nonhazardous.Refer
to Charger Connector on page 11.
• Do not charge the main battery unless the area is known
to be nonhazardous. Refer to Enpac Ex Battery Pack on
page 13.
• Do not connect the Enpac Ex to a PC using the RS-232
interface unless the area is known to be nonhazardous.
Refer to RS-232 Interface on page 12.