Offroute user parameters – Rockwell Automation 441-PEN25 Enpac Ex Data Collector User Manual
Page 118

Publication GMSI00-UM001A-EN-E - February 2005
112 Enpac Ex Parameters
Offroute User Parameters
The Offroute User parameters define a user-defined measurement point. Use
the parameters when collecting an off route measurement. Refer to Creating
and Collecting a User-Defined Point on page 92 for more information.
Offroute User Parameters
Parameter Name
Description
Values/Comments
Change Name
Changes the name of the user-defined measurement
point.
Select the hierarchy level for which you want to
change the name. A window opens at the bottom of
the screen. Use the numeric key pad to enter a new
name and tap the OK button.
Collection
The type of data to collect with this measurement.
• Overall/Signature - Collect both a magnitude
reading and a signature.
• Overall only - Collect a magnitude reading only.
• Signature only - Collect a signature only.
• Rss Overall - Collect a digital overall
measurement.
Options: Overall/Signature
Overall only
Signature only
RSS Overall
Display Format
The display format of the measurement.
Options: Spectrum
Time
Phase
Order
Units
The measurement units for the transducer.
Options: Disp (mil)
Disp (um)
Volts
EUs [S]
Temperature [S]
Current (A) [S]
Pressure (PSI) [S]
Flow (m
3
/s) [S]
Rot. Speed [S]
Linear displ. (mm) [S]
Count [S]
Count Rate [S]
Volts [S]
Accel (G) [S]
Vel. (IPS) [S]
Vel. (mm/s) [S]
Disp (mil) [S]
Disp (µm) [S]
Note: The [S] designation refers to a
static measurement that you must
manually enter with the numeric key
pad. All dynamic measurements and
temperature process points require a
transducer to make the measurement.