Frequently asked questions and answers, Setting up measurement definitions in emonitor, How do i set up measurement definitions – Rockwell Automation 441-PEN25 Enpac Ex Data Collector User Manual
Page 123: Why do unsupported selections appear in emonitor, Appendix c, Appendix

117
Publication GMSI00-UM001A-EN-E - February 2005
Appendix
C
Frequently Asked Questions and Answers
Appendix C contains the most frequently asked questions about using the
Enpac Ex with Emonitor.
Setting Up Measurement
Definitions in Emonitor
How do I set up measurement definitions?
Emonitor and the Enpac Ex can collect and store a wide range of types of
measurements. To take advantage of these capabilities, you must understand
how to set up the different types of measurement definitions. For examples of
setting up specific types of measurement definitions, see Setting Up
Measurement Definitions on page 46.
Why do unsupported selections appear in Emonitor?
Each data collector supports only certain selections in the drop down lists in
the Measurement Definition pane. Emonitor automatically displays the correct
selections when you select one or more active collectors. You select the active
collector or collectors using Tools > Set Active Collectors in Emonitor. If
you do not select the Enpac Ex as the active collector, it can affect the
selections in one of two ways:
• If you do not select any collectors, Emonitor displays all possible
selections, not just those for the Enpac Ex.
• If you select two or more different collectors, Emonitor displays only
the selections that are available for both collectors.
For information about
See page
Setting Up Measurement Definitions in Emonitor
Collecting Data with the Enpac Ex