Enpac ex parameters, Instrument setup parameters, Appendix b – Rockwell Automation 441-PEN25 Enpac Ex Data Collector User Manual
Page 111: Appendix
105
Publication GMSI00-UM001A-EN-E - February 2005
Appendix
B
Enpac Ex Parameters
Appendix B provides a list and description of the Enpac Ex parameters.
Instrument Setup
Parameters
The Instrument Setup parameters define the global options for the Enpac Ex
including the date, time, communication baud rate, and time-out. Use the
Touchscreen parameter to re-calibrate the touchscreen. The settings are
stored in Flash memory and will be reset to the factory defaults on a hardware
reset.
For information about
See page
Instrument Configuration Parameters
Instrument Setup Parameters
Parameter Name
Description
Values/Comments
Timeout
The number of minutes the Enpac Ex can remain idle
before it shuts itself off to conserve battery power.
Press the ON/OFF key to reactivate the instrument
following a timeout. The instrument returns to the
point in the program where it was when it shut off.
No stored data will be lost.
Options: 5 mins
10 mins
15 mins
20 mins
Off (default)
IrDA
Enables or disables the Infra-Red serial port.
The Enpac Ex does not currently
support this interface. We recommend
you set this option to "Disabled"
(default).
Baud Rate
The baud rate for the serial communication.
Options: 1200
2400
4800
9600
19200 (default)
38400
115200
Dflt Units
Defines the units of measurement for off route
standard velocity measurements.
Options: English (ips) (default)
Metric (mm/s)
Important: Used only for Off route
standard velocity measurements.
Date Format
The format of the date displayed in the Enpac Ex.
Options: DD/MM/YYYY
MM/DD/YYYY (default)
YYYY/MM/DD