Rockwell Automation 2364F Regenerative DC Bus Supply Unit (RGU) - Manual (Page 180)

Publication 2364F-5.01– October 2003
D-36 Programming Parameters
177
Host Fault Status Word 2
[Fault Status 2]
This parameter indicates a number of host fault
conditions.
1 - Fault 0 - No Fault
Parameter Type Source (Read Only)
Display Units None
Drive Units Display Units * 1
Factory Default 0000 0000 0000 0000
Minimum Value 0000 0000 0000 0000
Maximum Value 1111 1111 1111 1111
Related Parameters P178, P179
P178 and P179 determine what conditions are
reported and how the conditions are to be
handled (warning/fault).
Bit Description
0 Desaturizatn Indicates a desaturization fault.
1 Board Intlk Indicates a board interlock condition.
2 HW Bus OverV Indicates that the bus is operating at overvoltage (hardware).
3 HW Line I Indicates a fault in the line current (hardware).
4 Zero Seq Err Indicates an zero sequnce error.
5 Phase Lock L Indicates an error in the phase lock loop.
6 Phase Loss Indicates a phase has been lost from the AC line.
7 Not Used
8 Not Used
9 Not Used
10 SW Line I Indicates a fault in the line current (software).
11 I Offset Err Indicates a current offset fault.
12 DualPort TO Indicates an error in the dual port time out.
13 Not Used
14 Not Used
15 DSP Fault Indicates a fault in the DSP.
178
Fault Status 2 Report Mask
[Flt Report Mask 2]
This parameter selects the faults that can be
reported to P177.
1 - Report 0 - Suppress
Parameter Type Sink (Read/Write)
Display Units None
Drive Units Display Units * 1
Factory Default 1111 1111 1111 1111
Minimum Value 0000 0000 0000 0000
Maximum Value 1111 1111 1111 1111
Related Parameters P177, P179
Bit Description Bit Description
0* Desaturizatn Reports desaturization errors. 8 Not Used
1* Board Intlk Reports board interlock errors. 9 Not Used
2* HW Bus OverV Reports bus overvoltage conditions (hardware). 10* SW Line I Reports line current conditions (software)
3* HW Line I Reports line current conditions (hardware). 11* I Offset Err Reports current offset errors.
4* Zero Seq Err Reports zero sequence errors. 12* DualPort TO Reports errors in the dual port time out.
5* Phase Lock L Reports phase lock loop. 13 Not Used
6* Phase Loss Reports phase losses in the AC line. 14 Not Used
7 Not Used 15* DSP Fault Reports DSP faults.
* These items cannot be changed to zero.
Bit
8
Bit
9
Bit
10 Bit
11 Bit
12 Bit
13 Bit
14 Bit
15 Bit
0
Bit
1
Bit
2
Bit
3
Bit
4
Bit
5
Bit
6
Bit
7
Bit
8
Bit
9
Bit
10 Bit
11 Bit
12 Bit
13 Bit
14 Bit
15 Bit
0
Bit
1
Bit
2
Bit
3
Bit
4
Bit
5
Bit
6
Bit
7