Rockwell Automation 2364F Regenerative DC Bus Supply Unit (RGU) - Manual (Page 159)

Publication 2364F-5.01– October 2003
Programming Parameters D-15
52
D/A Converter 1 Frequency
[DAC1 Cutoff Freq]
This parameter determines the cutoff frequency
for the value being sent to DAC1 (which is
indicated by P49 [D/A Converter Source]). This
action is applied after the offset (P50) and gain
(P51).
To turn the filter off, set this to 0.
Parameter Type Sink (Read/Write)
Display Units R/S (rads/sec)
Drive Units Display Units * 10
Factory Default 0 (Filter Off)
Minimum Value 0
Maximum Value 3276.7
Related Parameters P47, P49, P50, P51
See Chapter 11
The P47 listing (D/A Converter 1 Output) shows
a diagram of the DAC process.
53
D/A Converter 2 Source
[DAC2 Indirect]
This parameter identifies the parameter value
which will be sent to DAC2 and out to Analog Out
2. The P48 listing (D/A Converter 2 Output)
shows a diagram of the DAC process.
The default selection is P108 (Total Line Current).
Parameter Type Sink (Read/Write)
Display Units Parameter Number
Drive Units Display Units * 1
Factory Default 108 (Total Line Current)
Minimum Value 0
Maximum Value Maximum Defined Parameter Number
Related Parameters P48, P54, P55, P56
See Chapter 11
54
D/A Converter 2 Offset
[DAC2 Offset]
This parameter determines the +/- adjustment
made to the value being sent to DAC2 (which is
indicated by P53 [D/A Converter Source]). This
offset is applied before the gain (P55).
The P47 listing (D/A Converter 1 Output) shows a
diagram of the DAC process.
Parameter Type Sink (Read/Write)
Display Units None
Drive Units Display Units * 1
Factory Default 0
Minimum Value -32767
Maximum Value 32767
Related Parameters P48, P53, P55, P56
See Chapter 11
55
D/A Converter 2 Gain
[DAC2 Gain]
This parameter determines the gain adjustment
made to the value being sent to DAC2 (which is
indicated by P53 [D/A Converter Source]). This
gain is applied after the offset (P54).
The P47 listing (D/A Converter 1 Output) shows a
diagram of the DAC process.
Parameter Type Sink (Read/Write)
Display Units None
Drive Units Display Units * 256
Factory Default 0.25
Minimum Value -128.00
Maximum Value 128.00
Related Parameters P48, P53, P54, P56
See Chapter 11
56
D/A Converter 2 Frequency
[DAC2 Cutoff Freq]
This parameter determines the cutoff frequency
for the value being sent to DAC2 (which is
indicated by P53 [D/A Converter Source]). This
action is applied after the offset (P54) and gain
(P55).
To turn the filter off, set this to 0.
Parameter Type Sink (Read/Write)
Display Units R/S (rads/sec)
Drive Units Display Units * 10
Factory Default 0 (Filter Off)
Minimum Value 0
Maximum Value 3276.7
Related Parameters P48, P53, P54, P55
See Chapter 11
The P47 listing (D/A Converter 1 Output) shows
a diagram of the DAC process.
57-59
P57-P59 are for internal use only.