Rockwell Automation 1756-DMF30 ControlLogix Drive Module - Manual (Page 30)

Publication 1756-UM522B-EN-P - February 2003
3-4 Drive Module Features
Class I Division 2 Certification
The ControlLogix Drive module is certified for use in nonhazardous
locations as well as Class I, Division 2 hazardous Locations containing
gas groups A, B, C, and D. This equipment may be used as a
component of a control system which is certified to operate in
hazardous locations.
Agency Certification
When the Drive module is marked appropriately, the following
agency certifications apply:
•
UL Listed Industrial Control Equipment
•
CSA Certified Process Control Equipment
•
CSA Certified for Class I, Division 2 Hazardous Locations
Configurable Module
Features The following Drive module features are configurable via RSLogix
5000 and DriveExecutive:
•
Controller Communication Format
•
SynchLink Controller Communication Format
•
Electronic Keying
•
Requested Packet Interval
•
Transmitted Direct Words
•
SynchLink Mastership
WARNING
!
When you insert or remove the module while
backplane power is on, an electrical arc can occur.
This could cause an explosion in hazardous location
installations. Be sure that power is removed or the
area is nonhazardous before proceeding.
ATTENTION
!
The removal of a Drive Module while under power
may cause personal injury or property damage. Make
sure that removal of the module does not adversely
impact other parts of the system.