Rockwell Automation 1756-DMF30 ControlLogix Drive Module - Manual (Page 274)

Publication 1756-UM522B-EN-P - February 2003
C-22 1756-DMF30 Specific Information
169 Drive I/O Status
Indicates status of PMI functions.
Default: 0000 0000 0000 0000
Options Bit 0
Bit 1
Bit 2
Bit 3
Bit 4
Bit 5
Bit 6
Bit 7
Bit 8
Bit 9
Bti 10
Bit 11
Bit 12
Bit 13
Bit 14
Bit 15 Run Perm
M-Cont Fdbk
Aux In 2
Aux In 3
Aux In 4
Aux In 5
Res Gain OK
Res Bal OK
StrobeDetect
Strobe Level
Reserved
Reserved
Reserved
Reserved
Reserved
Reserved
File:
Group: Utility
Diagnostics
210 PeakDtct Ctrl In
Sets configuration of the two peak/level detectors.
• Set mode is a level detector which causes the output to match the
preset when the input exceeds the preset.
• Hold mode is a level detector which causes the output to match the
input, the moment it detects the input exceeding the preset.
• Regular peak detection (when set and hold are off) causes the output
to match the input at the moment a peak is detected.
• Sel determines if the peak/level detector is positive of negative. If the
bit is set the detector detects positive peaks or levels above the preset.
If the bit is not set the detector detects negative "valleys" or levels
below the preset.
Default: 0000 0000 0000 0000
Options Bit 0
Bit 1
Bit 2
Bit 3
Bit 4
Bit 5
Bit 6
Bit 7 Peak 1 Set
Peak 1 Hold
Peak 1 Sel
Reserved
Peak 2 Set
Peak 2 Hold
Peak 2 Sel
Reserved
File:
Group: Utility
Peak Detection
211 Peak Ctrl Status
Status of peak/level detectors. A peak detector sets its bit
when it detects a peak or when its input exceeds its preset -
depending on mode.
Default: 0000 0000 0000 0000
Options Bit 0
Bit 1
Bit 2
Bit 3
Bit 4
Bit 5
Bit 6
Bit 7 Peak 1 Chng
Peak 2 Chng
Reserved
Reserved
Reserved
Reserved
Reserved
Reserved
File:
Group: Utility
Peak Detection
212 PeakDtct1 In Int
Integer input to the first peak/level detector.
Default:
Min:
Max:
Type:
File:
Group: 0
-2147483648
2147483648
Linkable, Read-Write, 32-Bit Integer
Utility
Peak Detection
No. Name
Description Values