Rockwell Automation 1336T FORCE Series B - Manual (Page 82)

Chapter 3
Programming Terminals
3–16
or
or
or
or
or
Password Mode The factory default password is 0 (which
disables password protection). To change the
password and enable password protection,
perform the following steps.
From the Status Display, press Enter (or
any key). “Choose Mode” will be
shown.
Press the Increment (or Decrement) key
until “Password” is displayed.
Press Enter.
Press the Increment (or Decrement) key
until “Modify” is displayed.
Press Enter. “Enter Password” will be
displayed.
Press the Increment (or Decrement) key
to scroll to your desired new password.
With a Series A (version 3.0) or Series
B HIM, the SELect key will move the
cursor.
Press Enter to save your new password.
Press Enter again to return to the
Password Mode.
Press the Increment (or Decrement) key
until “Logout” is displayed.
Press Enter to log out of the Password
mode.
With a Series A (version 3.0) or Series
B HIM, the Password mode can be
programmed to appear when drive
power is applied. Simultaneously press
the Increment and Decrement keys
while the Password display is shown.
Sets Password Display
as Power-Up Display
Choose Mode
Password
Choose Mode
Display
Password
Modify
Enter Password
< 0>
Enter Password
< 123>
Choose Mode
Password
Password
Login
Password
Logout
Choose Mode
Password