Rockwell Automation 1336T FORCE Series B - Manual (Page 80)

Chapter 3
Programming Terminals
3–14
AB0270A
or
or
or
(continued) Control Status Mode
Fault Queue/Clear Faults
This menu provides a means to view the
fault queue and clear it when desired.
From the Control Status menu, press the
Increment (or Decrement) key until
“Fault Queue” is displayed.
Press Enter.
Press the Increment (or Decrement) key
until “View Queue” is displayed.
Press Enter. The fault queue will be
displayed. “Trip” displayed with a fault
will indicate the fault that tripped the
drive.
Use the Increment (or Decrement) key
to scroll through the list.
If you wish to view the time and date of
the fault occurrence, press the Enter key.
To clear the fault queue, press ESCape.
Then use the Increment/Decrement keys
to select “Clear Queue.” Press Enter.
Please note that “Clear Queue” will not
clear active faults.
Control Status
Fault Queue
Fault Queue
View Queue
Serial Fault
F 10 Trip 1
Reprogram Fault
F 48 2
1:20:22 1/1
or
Fault Queue
Clear Queue