Rockwell Automation 25-COMM-D PowerFlex 525 DeviceNet Adapter - Manual (Page 90)

90 Rockwell Automation Publication 520COM-UM002A-EN-E - April 2013
Chapter 8 Troubleshooting
45 Net IO Close An I/O connection from the network to the adapter was closed.
46 Net Idle Fault The adapter detected a network idle condition on the network and has performed the
“Idle Flt” action specified by the user.
47 Net IO Open An I/O connection from the network to the adapter has been opened.
48 Net IO Timeout An I/O connection from the network to the adapter has timed out.
49 Net IO Size Err The adapter received an incorrectly sized I/O packet.
50 PCCC IO Close The device sending PCCC Control messages to the adapter has set the PCCC Control
Timeout to zero.
51 PCCC IO Open The adapter has begun receiving PCCC Control messages (the PCCC Control Timeout
was previously set to a non-zero value).
52 PCCC IO Timeout The adapter has not received a PCCC Control message for longer than the PCCC Control
Timeout.
53 Msg Ctrl Open The timeout attribute in either the CIP Register or Assembly object was written with a
non-zero value, allowing control messages to be sent to the adapter.
54 Msg Ctrl Close The timeout attribute in either the CIP Register or Assembly object was written with a
zero value, disallowing control messages to be sent to the adapter.
55 Msg Ctrl Timeout The timeout attribute in either the CIP Register or Assembly object elapsed between
accesses of those objects.
58 Net Bus Off The network has experienced a Bus Off condition.
59 Net Poll Timeout A Polled I/O connection has timed out.
60 Net IO Frag Err A network I/O fragment was received out of sequence. Possible line noise problem.
61 Net COS Timeout A Change of State (COS) connection has timed out.
62 Net Poll Alloc A Polled connection has been allocated.
63 Net COS Alloc A Change of State (COS) I/O connection has been allocated.
64 Net Poll Close A Polled I/O connection was explicitly closed.
65 Net COS Close A Change of State (COS) I/O connection was explicitly closed.
Adapter Specific Events
69 Module Defaulted The adapter has been set to defaults.
Adapter Events
Code Event Description