Lenze ECSCMxxx - Manual (Page 108)

Commissioning
Holding brake configuration
Opening the brake
6
l
108 EDBCSXM064 EN 11.0
6.6.2 Opening the brake
t
t
t
t
t
t
t
0
1

‚
ƒ
C0244
C0196
CtrlWord.Bit7
CtrlWord.Bit9
QSP
NSet
MAct
C0244
X6/B+
 Use control bit 7 = 1 (TRUE) to enable the
controller. The control bit 9 is set to 0 (FALSE) at
the same time (controller inhibit (CINH) is
deactivated) and the torque defined in C0244 is
created. This happens within the brake opening
time set in C0196.
‚ As soon as the torque (Mact) has reached the
value in C0244, the brake is opened.
ƒ If the brake is opened via the digital output
X6/B+, the following happens after the brake
opening time has elapsed (C0196)
l Quick stop (QSP) is cancelled.
l Setpoint integrator is enabled.
ECSXA519
CtrlWord.Bit7 Controller enable (control bit 7)
CtrlWord.Bit9 Controller inhibit (control bit 9)
Mact Actual torque
X6/B+ Digital output X6/B+
QSP Quick stop (QSP)
Nset Setpoint speed
0 Brake is closed
1 Brake is open