Lenze ECSCMxxx - Manual (Page 2)

l
2 EDBCSXM064 EN 11.0
,
Please read these instructions before you start working!
Follow the enclosed safety instructions.
This documentation is valid for ECSxM axis modules, "Motion" application software from V 1.2, as of
version:

ECS x M xxx x 4 x xxx XX xx xx
Device type
A
TTENTION
L ´appareil est sous tension pendant 180s après la coupure de la tension réseau
W
ARNING
Device is live up to 180s after removing mains voltage

Design
E = standard panel−mounted unit, IP20
D = push−through technique (thermally separated)
C = cold−plate technique
Application
M = "Motion"
Peak current
004 = 4 A
008 = 8 A
016 = 16 A 032 = 32 A
048 = 48 A
064 = 64 A
Fieldbus interface
C = MotionBus/system bus (CAN)
Voltage class
4 = 400 V/500 V
Technical version
B = standard
V = coated
I = for IT systems, uncoated
K= for IT systems, coated
Variant
042 = Motion CiA402
Hardware version
1A or higher
Operating software version (B−SW)
6.0 or higher
0Fig. 0Tab. 0
© 2013 Lenze Drive Systems GmbH, Hans−Lenze−Straße 1, 31855 Aerzen
No part of this documentation may be reproduced or made accessible to third parties without written consent by Lenze Drive Sy-
stems GmbH.
All information given in this documentation has been selected carefully and complies with the hardware and software described.
Nevertheless, discrepancies cannot be ruled out. We do not take any responsibility or liability for any damage that may occur. Ne-
cessary corrections will be included in subsequent editions.