Lenze ECSCMxxx - Manual (Page 109)

Commissioning
Setting of the feedback system for position and speed control
6
l
109 EDBCSXM064 EN 11.0
6.7 Setting of the feedback system for position and speed control
The following feedback systems can be selected for position and speed control:
ƒ Resolver (
¶ 110)
ƒ TTL incremental encoder/SinCos encoder without serial communication (
¶ 113)
– as position and speed encoder ( ¶ 113)
– as position encoder and resolver as speed encoder (
¶ 117)
ƒ Absolute value encoder (Hiperface®, single−turn/multi−turn)
– as position and speed encoder (
¶ 121)
– as position encoder and resolver as speed encoder (
¶ 126)
The GDC includes the parameters or codes to be set in the parameter menu under
Short setup
W Feedback system:
ECSXA532
Fig. 6−8 GDC view: Commissioning of the feedback system
)
Note!
If the Lenze setting has been loaded via C0002, the feedback system must be
reset.