Emergency operations – SkyTrak 3606 Operation Manual User Manual
Page 98
96
3606 Rev 11/99
Emergency Operations
9. Reattach the faulty hose and direct the line so any oil that escapes
will be caught by the container.
10. Close the rear cover.
11. Check the hydraulic oil level and add oil if needed.
12. Remove the blocking or support from the outer boom.
13. Return to the cab, fasten your seat belt and start the engine.
14. Tilt the carriage and/or attachment upward if necessary for clear-
ance before retracting the boom.
15. Slowly retract the boom.
16. Slowly lower the boom and ground the carriage.
17. Completely remove the load from the carriage and/or attachment if
you haven’t already done so.
18. Have the vehicle serviced immediately.
19. Replace any faulty hydraulic lines.
20. Return to the cab, fasten your seat belt and start the engine.
21. Cycle the lift cylinder several times to bleed air from the system.
Check for leaks.
22. Transfer the waste oil to a container with a cover and label as used
oil. Dispose of properly.
23. Recheck the hydraulic oil level. Add oil if necessary.
96
3606 Rev 11/99
Emergency Operations
9. Reattach the faulty hose and direct the line so any oil that escapes
will be caught by the container.
10. Close the rear cover.
11. Check the hydraulic oil level and add oil if needed.
12. Remove the blocking or support from the outer boom.
13. Return to the cab, fasten your seat belt and start the engine.
14. Tilt the carriage and/or attachment upward if necessary for clear-
ance before retracting the boom.
15. Slowly retract the boom.
16. Slowly lower the boom and ground the carriage.
17. Completely remove the load from the carriage and/or attachment if
you haven’t already done so.
18. Have the vehicle serviced immediately.
19. Replace any faulty hydraulic lines.
20. Return to the cab, fasten your seat belt and start the engine.
21. Cycle the lift cylinder several times to bleed air from the system.
Check for leaks.
22. Transfer the waste oil to a container with a cover and label as used
oil. Dispose of properly.
23. Recheck the hydraulic oil level. Add oil if necessary.