Warning – SkyTrak 3606 Operation Manual User Manual
Page 66
64
3606 Rev 11/99
Operation
Leveling the Vehicle
When placing a load on a slope, use the Frame Sway Control (see MODE 3
on page 27) to keep the vehicle level. The operator should observe the
frame level indicator to assure that the vehicle is level at all times.
Quick Attach
This vehicle is equipped with a quick attach system for easy attachment
changing.
Attachment Removal
1. Be sure you are performing this procedure on level ground.
2. Place the travel select lever in (N) NEUTRAL, come to a complete
stop and engage the parking brake switch.
3. Extend the boom approximately 10 feet (3,05 meters) and tilt the
carriage backward.
4. Exit the vehicle using both hand holds.
NOTE: If you are removing a standard carriage with forks, spread the forks
apart on the carriage shaft. This will provide the carriage adequate support
to stand alone.
5. Raise the quick attach pin lock lever and pull out the pin at the bot-
tom of the quick attach link (Figure 42).
WARNING
Use of frame sway control with the boom raised above horizontal can
cause tipover resulting in death or serious injury. Always use the sway
control to level the vehicle before raising the boom above horizontal. If
the vehicle cannot be leveled using the sway control, reposition the
vehicle.
64
3606 Rev 11/99
Operation
Leveling the Vehicle
When placing a load on a slope, use the Frame Sway Control (see MODE 3
on page 27) to keep the vehicle level. The operator should observe the
frame level indicator to assure that the vehicle is level at all times.
Quick Attach
This vehicle is equipped with a quick attach system for easy attachment
changing.
Attachment Removal
1. Be sure you are performing this procedure on level ground.
2. Place the travel select lever in (N) NEUTRAL, come to a complete
stop and engage the parking brake switch.
3. Extend the boom approximately 10 feet (3,05 meters) and tilt the
carriage backward.
4. Exit the vehicle using both hand holds.
NOTE: If you are removing a standard carriage with forks, spread the forks
apart on the carriage shaft. This will provide the carriage adequate support
to stand alone.
5. Raise the quick attach pin lock lever and pull out the pin at the bot-
tom of the quick attach link (Figure 42).
WARNING
Use of frame sway control with the boom raised above horizontal can
cause tipover resulting in death or serious injury. Always use the sway
control to level the vehicle before raising the boom above horizontal. If
the vehicle cannot be leveled using the sway control, reposition the
vehicle.