SkyTrak 3606 Operation Manual - Manual (Page 127)

General Maintenance
3606 Rev 11/99 125
To vent the high pressure fuel lines, loosen one fitting at the injector. Turn
the ignition key to the START position and crank the engine for a maximum
of 15 seconds or until fuel, free of air comes out of the injector fitting
(Figure 81). Tighten the fitting. Torque to 22 lb/ft (30 Nm). Repeat this
procedure for each fitting until the engine runs smooothly. With the engine
running, visually check for leaks. Turn ignition switch OFF.
Figure 81
WARNING
KEEP CLEAR of spraying fuel. Fuel will spray when venting high
pressure fuel lines. The fuel pressure is sufficient to penetrate the skin
and cause serious bodily injury. Wear protective clothing and safety
glasses.
OS0990
High
Pressure
Fuel Lines
Injector
General Maintenance
3606 Rev 11/99 125
To vent the high pressure fuel lines, loosen one fitting at the injector. Turn
the ignition key to the START position and crank the engine for a maximum
of 15 seconds or until fuel, free of air comes out of the injector fitting
(Figure 81). Tighten the fitting. Torque to 22 lb/ft (30 Nm). Repeat this
procedure for each fitting until the engine runs smooothly. With the engine
running, visually check for leaks. Turn ignition switch OFF.
Figure 81
WARNING
KEEP CLEAR of spraying fuel. Fuel will spray when venting high
pressure fuel lines. The fuel pressure is sufficient to penetrate the skin
and cause serious bodily injury. Wear protective clothing and safety
glasses.
OS0990
High
Pressure
Fuel Lines
Injector