SkyTrak 3606 Operation Manual - Manual (Page 49)

Operation
3606 Rev 11/99 47
The Cummins engine is equipped with a block heater. Block heaters are
recommended when temperatures drop below 10° F (-12° C).
(Temperature
ranges will vary when using different oil weights. Consult the engine
manufacturer’s manual for other variables.)
At temperatures below 10° F (-12° C), operate the engine at moderate
speeds for 5 minutes before full loads are applied.
1. Enter the cab and adjust the operator’s seat.
2. Fasten the seat belt. Adjust the mirrors if necessary.
3. Make sure the parking brake switch is ENGAGED.
4. Make sure the travel select lever is in the (N) NEUTRAL position.
5. Depress the accelerator pedal half way to the floor.
6. If using starting fluid with mechanical or electrical metering equip-
ment:
• turn the ignition switch to the START position to engage the
starter motor and inject metered amounts of starting fluid.
• as the engine starts, stop injection of starting fluid and release
the ignition key to the RUN position. Release the accelerator
pedal enough to provide a smooth idle speed.
Cold Starting (Cummins Engines Only)
WARNING
DO NOT start the engine unless you are in the seat with the seat belt
fastened around you. Serious injury or death could result if the belt is
not securely fastened.
Operation
3606 Rev 11/99 47
The Cummins engine is equipped with a block heater. Block heaters are
recommended when temperatures drop below 10° F (-12° C).
(Temperature
ranges will vary when using different oil weights. Consult the engine
manufacturer’s manual for other variables.)
At temperatures below 10° F (-12° C), operate the engine at moderate
speeds for 5 minutes before full loads are applied.
1. Enter the cab and adjust the operator’s seat.
2. Fasten the seat belt. Adjust the mirrors if necessary.
3. Make sure the parking brake switch is ENGAGED.
4. Make sure the travel select lever is in the (N) NEUTRAL position.
5. Depress the accelerator pedal half way to the floor.
6. If using starting fluid with mechanical or electrical metering equip-
ment:
• turn the ignition switch to the START position to engage the
starter motor and inject metered amounts of starting fluid.
• as the engine starts, stop injection of starting fluid and release
the ignition key to the RUN position. Release the accelerator
pedal enough to provide a smooth idle speed.
Cold Starting (Cummins Engines Only)
WARNING
DO NOT start the engine unless you are in the seat with the seat belt
fastened around you. Serious injury or death could result if the belt is
not securely fastened.