SkyTrak 3606 Operation Manual - Manual (Page 101)

Emergency Operations
3606 Rev 11/99 99
Figure 62
10. Check the hydraulic oil level and add oil if needed.
11. Return to the cab, fasten your seat belt and start the engine.
12. Tilt the carriage and/or attachment upward if necessary for clear-
ance before retracting the boom.
13. Slowly retract the boom.
14. Slowly lower the boom and ground the carriage and/or attachment.
15. Completely remove the load from the carriage and/or attachment if
you haven’t already done so.
16. Have the vehicle serviced immediately.
17. Replace any faulty hydraulic lines.
18. Return to the cab, fasten your seat belt and start the engine.
19. Cycle the extend cylinder several times to bleed air from the sys-
tem. Check for leaks.
20. Transfer the waste oil to a container with a cover and label as used
oil. Dispose of properly.
21. Recheck the hydraulic oil level. Add if necessary.
OS1140
Boom
Extend
Line
Base of
Extend
Cylinder
(Ref.)
Emergency Operations
3606 Rev 11/99 99
Figure 62
10. Check the hydraulic oil level and add oil if needed.
11. Return to the cab, fasten your seat belt and start the engine.
12. Tilt the carriage and/or attachment upward if necessary for clear-
ance before retracting the boom.
13. Slowly retract the boom.
14. Slowly lower the boom and ground the carriage and/or attachment.
15. Completely remove the load from the carriage and/or attachment if
you haven’t already done so.
16. Have the vehicle serviced immediately.
17. Replace any faulty hydraulic lines.
18. Return to the cab, fasten your seat belt and start the engine.
19. Cycle the extend cylinder several times to bleed air from the sys-
tem. Check for leaks.
20. Transfer the waste oil to a container with a cover and label as used
oil. Dispose of properly.
21. Recheck the hydraulic oil level. Add if necessary.
OS1140
Boom
Extend
Line
Base of
Extend
Cylinder
(Ref.)