General maintenance, Hydraulic oil and filter – SkyTrak 3606 Operation Manual User Manual
Page 130
128
3606 Rev 11/99
General Maintenance
A. Hydraulic Oil Level Check
(10 Hour Intervals)
1. Level the vehicle, ground the carriage, place the travel select lever
in (N) NEUTRAL, engage the parking brake switch.
2. Fully retract all hydraulic cylinders and shut off the engine.
3. Unlatch, unlock and open the engine cover.
4. Allow the hydraulic oil to cool.
5. Locate the sight glass along the vertical wall of the hydraulic tank
(Figure 84). Check the level of the hydraulic oil in the tank. The oil
level should be visible at the lower end of the sight glass. If oil is not
visible, remove the hydraulic oil fill cap and add oil (ISO Grade 46
Hydraulic Oil) until the oil level is visible at the lower end of the sight
glass. DO NOT overfill.
6. Reinstall the hydraulic oil fill cap.
7. Close, latch and lock the engine cover.
Figure 84
8. Hydraulic Oil and Filter
OS0660
OS1590
Hydraulic
Oil
Sight
Glass
128
3606 Rev 11/99
General Maintenance
A. Hydraulic Oil Level Check
(10 Hour Intervals)
1. Level the vehicle, ground the carriage, place the travel select lever
in (N) NEUTRAL, engage the parking brake switch.
2. Fully retract all hydraulic cylinders and shut off the engine.
3. Unlatch, unlock and open the engine cover.
4. Allow the hydraulic oil to cool.
5. Locate the sight glass along the vertical wall of the hydraulic tank
(Figure 84). Check the level of the hydraulic oil in the tank. The oil
level should be visible at the lower end of the sight glass. If oil is not
visible, remove the hydraulic oil fill cap and add oil (ISO Grade 46
Hydraulic Oil) until the oil level is visible at the lower end of the sight
glass. DO NOT overfill.
6. Reinstall the hydraulic oil fill cap.
7. Close, latch and lock the engine cover.
Figure 84
8. Hydraulic Oil and Filter
OS0660
OS1590
Hydraulic
Oil
Sight
Glass