General maintenance – SkyTrak 3606 Operation Manual User Manual
Page 110

108
3606 Rev 11/99
General Maintenance
6. Position the air cleaner cover in place and secure it by latching the
three retaining clips.
Figure 66
Carefully follow these procedures to clean a primary element:
1. Remove loose particles from the filter with compressed air [maxi-
mum 30 psi (207 kPa)] or water hose [maximum 40 psi (276 kPa)
without nozzle.] Rotate and apply pressure from the inside of the
element.
2. Soak the filter in non-sudsing detergent (such as FM 1400) for at
least 15 minutes. Never soak longer than 24 hours.
3. Swish the filter around in the solution to remove loosened dirt parti-
cles.
4. Rinse the filter from the inside out with a gentle stream of water to
remove all dirt and suds [less than 40 psi (276 kPa), no nozzle.] If
the inside of the element has been contaminated with dirty water
from the soaking, rinse both sides.
Air
Cleaner
Cover
Primary
Element
Safety
Element
Air
Cleaner
Canister
Vactuator
Valve
(Ref.)
OS0450
108
3606 Rev 11/99
General Maintenance
6. Position the air cleaner cover in place and secure it by latching the
three retaining clips.
Figure 66
Carefully follow these procedures to clean a primary element:
1. Remove loose particles from the filter with compressed air [maxi-
mum 30 psi (207 kPa)] or water hose [maximum 40 psi (276 kPa)
without nozzle.] Rotate and apply pressure from the inside of the
element.
2. Soak the filter in non-sudsing detergent (such as FM 1400) for at
least 15 minutes. Never soak longer than 24 hours.
3. Swish the filter around in the solution to remove loosened dirt parti-
cles.
4. Rinse the filter from the inside out with a gentle stream of water to
remove all dirt and suds [less than 40 psi (276 kPa), no nozzle.] If
the inside of the element has been contaminated with dirty water
from the soaking, rinse both sides.
Air
Cleaner
Cover
Primary
Element
Safety
Element
Air
Cleaner
Canister
Vactuator
Valve
(Ref.)
OS0450