SkyTrak 3606 Operation Manual - Manual (Page 132)

130 3606 Rev 11/99
General Maintenance
5. Rotate and remove the filter head (Figure 86).
6. Remove the seal, and the element from the filter head (Figure 86).
Dispose of element and seal properly.
7. Clean the filter head sealing surface.
Figure 86
8. Place a receptacle under the hydraulic reservoir drain plug. The
receptacle must be large enough to hold 32 gallons (121 liters) of
oil. Remove the magnetic drain plug and allow the oil to drain into
the receptacle. Clean any loose particles attached to the drain plug.
Transfer the oil to a container with a cover and label the container
as used oil. Dispose of properly.
9. Re-install the magnetic drain plug into the reservoir.
10. Re-install the top seal and push a new filter element all the way
onto the filter head until it seats. Slide the assembly into the reser-
voir and secure.
11. Remove the fill cap and fill with ISO Grade 46 Hydraulic Oil until the
oil level is visible within the lower end of the sight glass. Reservoir
capacity is 32 gallons (121,9 liters). Re-install the fill cap.
12. Close, latch and lock the engine cover.
Filter
Head
Element
Seal
Sight Glass
Hydraulic
Reservoir
Drain Plug OS1601
130 3606 Rev 11/99
General Maintenance
5. Rotate and remove the filter head (Figure 86).
6. Remove the seal, and the element from the filter head (Figure 86).
Dispose of element and seal properly.
7. Clean the filter head sealing surface.
Figure 86
8. Place a receptacle under the hydraulic reservoir drain plug. The
receptacle must be large enough to hold 32 gallons (121 liters) of
oil. Remove the magnetic drain plug and allow the oil to drain into
the receptacle. Clean any loose particles attached to the drain plug.
Transfer the oil to a container with a cover and label the container
as used oil. Dispose of properly.
9. Re-install the magnetic drain plug into the reservoir.
10. Re-install the top seal and push a new filter element all the way
onto the filter head until it seats. Slide the assembly into the reser-
voir and secure.
11. Remove the fill cap and fill with ISO Grade 46 Hydraulic Oil until the
oil level is visible within the lower end of the sight glass. Reservoir
capacity is 32 gallons (121,9 liters). Re-install the fill cap.
12. Close, latch and lock the engine cover.
Filter
Head
Element
Seal
Sight Glass
Hydraulic
Reservoir
Drain Plug OS1601