Danger, General maintenance, Wheels and tires – SkyTrak 3606 Operation Manual User Manual
Page 140

138
3606 Rev 11/99
General Maintenance
A. Tire Air Pressure Check
(10 Hour Intervals)
Check all four tires:
1. Remove the valve stem cap.
2. Check tire pressure using a good quality gauge. You cannot tell if a
tire is properly inflated simply by looking at it.
3. Add air if required. Fill the tire(s) to 65 psi (448 kPa).
Do not overinflate.
4. Replace the valve stem cap.
B. Wheel Lug Nut Torque Check
1. Wire brush the area around the lug nuts if necessary.
2. Using the torque sequence chart below (Figure 94), alternately
check the torque of each of the ten lug nuts. The recommended
torque should be 370 lb/ft (500 Nm).
Figure 94
13. Wheels and Tires
DANGER
LOW TIRE PRESSURE can result in tipover.
MAINTAIN proper tire pressure at all times.
OS0900
OS0740
4
8
2
1
9
5
7
3
10
6
138
3606 Rev 11/99
General Maintenance
A. Tire Air Pressure Check
(10 Hour Intervals)
Check all four tires:
1. Remove the valve stem cap.
2. Check tire pressure using a good quality gauge. You cannot tell if a
tire is properly inflated simply by looking at it.
3. Add air if required. Fill the tire(s) to 65 psi (448 kPa).
Do not overinflate.
4. Replace the valve stem cap.
B. Wheel Lug Nut Torque Check
1. Wire brush the area around the lug nuts if necessary.
2. Using the torque sequence chart below (Figure 94), alternately
check the torque of each of the ten lug nuts. The recommended
torque should be 370 lb/ft (500 Nm).
Figure 94
13. Wheels and Tires
DANGER
LOW TIRE PRESSURE can result in tipover.
MAINTAIN proper tire pressure at all times.
OS0900
OS0740
4
8
2
1
9
5
7
3
10
6