General maintenance, Axle oil – SkyTrak 3606 Operation Manual User Manual
Page 135
![background image](/manuals/546094/135/background.png)
General Maintenance
3606 Rev 11/99
133
8. Check the transmission level and add 10W Motor Oil as required
following the procedures outlined in “Transmission Oil Level Check”
on page 131.
9. Close, latch and lock the engine cover.
A. Axle Oil Level Check
(250 Hour Intervals)
1. Level the vehicle, ground the carriage, place the travel select lever
in (N) NEUTRAL, engage the parking brake switch and shut off the
engine.
2. Clean the area around the axle fill/level plug (Figure 89), remove
the plug from the axle housing.
3. Add SAE 80W90 or SAE 80W140 Oil to bring the oil level up and
even with the plug hole.
4. Re-install the axle fill/level plug.
Figure 89
10. Axle Oil
OS0920
OS1581
Axle
Fill/Level
Plug
(FRONT AXLE SHOWN - REAR AXLE SIMILAR)
Drain
Plug
General Maintenance
3606 Rev 11/99
133
8. Check the transmission level and add 10W Motor Oil as required
following the procedures outlined in “Transmission Oil Level Check”
on page 131.
9. Close, latch and lock the engine cover.
A. Axle Oil Level Check
(250 Hour Intervals)
1. Level the vehicle, ground the carriage, place the travel select lever
in (N) NEUTRAL, engage the parking brake switch and shut off the
engine.
2. Clean the area around the axle fill/level plug (Figure 89), remove
the plug from the axle housing.
3. Add SAE 80W90 or SAE 80W140 Oil to bring the oil level up and
even with the plug hole.
4. Re-install the axle fill/level plug.
Figure 89
10. Axle Oil
OS0920
OS1581
Axle
Fill/Level
Plug
(FRONT AXLE SHOWN - REAR AXLE SIMILAR)
Drain
Plug