General maintenance – SkyTrak 3606 Operation Manual User Manual
Page 125

General Maintenance
3606 Rev 11/99
123
Figure 79
2. If the fuel system or a component in the system has been drained
or run out of fuel continue with Step 2, otherwise skip to Step 3.
Ensure that the ignition switch is in the OFF position. Loosen one of
the high pressure connections at the injector. Operate the starter
motor until fuel, free of air, comes out of the pipe connection.
Tighten the connections to 16 lb/ft (22 Nm). The fuel system has
been bled of air.
3. Turn the ignition switch to the START position to start the engine.
OS0731
Vent
Plug
Filter
Head
High
Pressure
Line
Injector
(PERKINS ENGINE)
General Maintenance
3606 Rev 11/99
123
Figure 79
2. If the fuel system or a component in the system has been drained
or run out of fuel continue with Step 2, otherwise skip to Step 3.
Ensure that the ignition switch is in the OFF position. Loosen one of
the high pressure connections at the injector. Operate the starter
motor until fuel, free of air, comes out of the pipe connection.
Tighten the connections to 16 lb/ft (22 Nm). The fuel system has
been bled of air.
3. Turn the ignition switch to the START position to start the engine.
OS0731
Vent
Plug
Filter
Head
High
Pressure
Line
Injector
(PERKINS ENGINE)