Operation – SkyTrak 3606 Operation Manual User Manual
Page 48
46
3606 Rev 11/99
Operation
5. Turn and hold the ignition switch to the PREHEAT position until the
preheat indicator light on the display panel stops flashing and glows
steadily. Release the switch immediately after the light goes out.
For location of the preheat indicator light on the display panel see
page 33.
Figure 30
6. Depress the accelerator pedal completely.
7. Turn the ignition switch to the START position to engage the starter
motor. As the engine starts, release the ignition key to the RUN
position. Release the accelerator pedal enough to provide a smooth
idle speed.
8. If the engine does not start in 15 seconds, return the ignition key to
the PREHEAT position for an additional 10 seconds and then
engage the starter motor again.
OF0390
OFF
RUN
PREHEAT
START
46
3606 Rev 11/99
Operation
5. Turn and hold the ignition switch to the PREHEAT position until the
preheat indicator light on the display panel stops flashing and glows
steadily. Release the switch immediately after the light goes out.
For location of the preheat indicator light on the display panel see
page 33.
Figure 30
6. Depress the accelerator pedal completely.
7. Turn the ignition switch to the START position to engage the starter
motor. As the engine starts, release the ignition key to the RUN
position. Release the accelerator pedal enough to provide a smooth
idle speed.
8. If the engine does not start in 15 seconds, return the ignition key to
the PREHEAT position for an additional 10 seconds and then
engage the starter motor again.
OF0390
OFF
RUN
PREHEAT
START