Wiping the ink cartridge nozzles and contacts, Nozzles, Contacts – Xerox WorkCentre 470cx-9904 User Manual
Page 268: Carrier contacts in the printer, Follow this procedure
Book
TOC
Chapter
TOC
Search
8-14
If the bottom line shows improvement, rerun this test. If
improvement continues, rerun the test. If all nozzles are not
printing after running the test three times, continue with step 5.
5
If print quality does not improve, remove and reinstall the ink
cartridge. Repeat the nozzle test.
6
If the line is still broken, wipe the nozzles and contacts. Refer to
Wiping the Ink Cartridge Nozzles and Contacts
Wiping the Ink Cartridge Nozzles and Contacts
If print quality does not improve after repeating the nozzle test, the
problem may be caused by dried ink on the ink cartridge:
• nozzles
• contacts
• carrier contacts in the printer
Follow this procedure:
1
Remove the ink cartridge. See
2
Use a clean, lint free cloth, dampened with water only, to gently
clean the entire copper colored area, including the nozzles and
contacts. To dissolve any dried ink, hold the damp cloth against
the nozzles for about three seconds. Gently blot and wipe dry.
Previous Page
Next Page