Xerox WorkCentre 470cx-9904 - Manual (Page 15)

Book
TOC
Chapter
TOC
Search
1-9
To connect the WorkCentre 470cx to a computer, follow
the steps below:
CAUTION: Make sure the computer is turned off, and the
WorkCentre 470cx is unplugged from the power outlet.
1 Plug the parallel cable into the connector on the back of the
WorkCentre 470cx. Swing the metal clips of the connector
inward until they lock firmly inside the notches on the parallel
cable connector.
2 Connect the other end of the cable to the parallel port on your
computer. Refer to your computer documentation for assistance
with this procedure.
Previous Page Next Page