The paper does not feed into the printer, The ink cartridge may be empty – Xerox WorkCentre 470cx-9904 User Manual
Page 240
Book
TOC
Chapter
TOC
Search
7-20
The paper does not feed
into the printer.
• Paper has not been loaded properly.
Remove and re-insert the paper correctly.
Refer to
• There is too much paper in the Automatic
Paper Feeder. Decrease the number of
sheets of paper in the Automatic Paper
Feeder.
Half of the printed page is
blank.
• The page layout is too complex. Simplify
the page layout, and remove any
unnecessary graphics from the document.
• The page orientation setting may be
incorrect. Change the page orientation in
the Print Setup dialog box.
• The paper size and the software paper size
settings do not match. Load the correct
paper in the printer or change the software
paper size settings in the Print Setup
dialog box.
• Scaling may be set to less than 100%.
Change the scaling setting in the Paper/
Output dialog box.
• The printer cable may be incorrect. Use or
replace the cable with an IEEE-1284 rated
cable.
• The ink cartridge may be empty.
Symptom
Cause and Solution
Previous Page
Next Page