Allied Telesis AT-S25 - Manual (Page 87)

AT-S25 Management Software User’s Guide
87
Deleting a Port Trunk
Caution
Disconnect the cables from the port trunk on the switch before
performing the following procedure. Deleting a port trunk without
first disconnecting the cables can create loops in your network
topology, which can result in broadcast storms and poor network
performance.
To delete a port trunk from the switch, perform the following procedure:
1. From the Main Menu, type 1 to select Ports Menu.
2. From the Ports Menu, type 3 to select Port Trunking.
The Port Trunking menu in Figure 29 on page 82 is displayed.
3. To delete a port trunk from a module other than the one currently
selected, type M.
The prompt message is displayed:
Select Module ID: [1 to 8] ->
4. Enter the ID of the module you want to select, and press the Enter key.
5. From the Port Trunking menu, type 5 to select Delete trunk.
The following prompt is displayed.
Enter Trunk Number -> [1 to 6] ->
6. Enter the number of the trunk you want to delete.
The following prompt is displayed.
Are you sure you want to delete the trunk (Y/N) ->
7. Type Y for Yes to delete the port trunk or N for No to cancel this
procedure.
If Y is selected, the port trunk is deleted from the switch.
8. Type S to select Save Configuration changes.