Allied Telesis AT-S25 - Manual (Page 159)

AT-S25 Management Software User’s Guide
159
Adding Static and Multicast MAC Addresses
This section contains the procedure for adding the static and multicast
addresses to the switch. You could assign up to 150 static MAC
addresses on a stack of an AT-8316F or an AT-8324 Switch.
To add a static or multicast address to the MAC Menu, perform the
following procedure:
1. From the Main Menu, type 6 to select MAC Menu.
2. From the MAC Menu, type 9 to select Add static MAC address.
The following prompt is displayed:
Please enter MAC address ->
3. Enter the static MAC address in the following format:
XXXXXX XXXXXX
Once you have specified the MAC address, the following prompts
are displayed:
Please enter VLAN ID -> [1 to 2048] ->
4. Enter the VID of the desired VLAN and press the Enter key.
Please enter a port number: [1 to 24] ->
5. Enter the number of the port on the switch to which you wish to
assign the address.
The management software adds the address to the MAC Menu.
6. Repeat steps 2 to 4 to enter additional static or multicast MAC
addresses.