Allied Telesis AT-S25 User Manual
Page 135
AT-S25 Management Software User’s Guide
135
should reflect the function of the nodes of the VLAN (for example,
Sales or Accounting). The name can not contain spaces nor special
characters, such as asterisks (*) or exclamation points (!).
7. You are now ready to add or delete ports from the VLAN. But before
you do, examine the prompt in the upper right portion of the window
to determine the switch module of the stack your management
session is currently addressing. If there are ports on this switch you
want to add or remove from the VLAN, then continue with the
following sub-steps. If this switch does not contain ports that you
want to add or remove from the VLAN, then go to the next step to
change switches.
To add or remove ports from the VLAN, do the following:
a. To add or remove tagged ports, type 3 to select Tagged Ports and
enter the new tagged port list at the prompt. You can specify the
ports individually (e.g., 2,5,11), as a range (e.g., 5-10), or both (e.g.,
3,7,11-15,17). To specify all ports on the switch, enter ALL. To
remove all tagged ports that are assigned to the VLAN from the
currently selected switch module, enter NONE.
b. To add or remove untagged ports, type 4 to select Untagged Ports
and enter the new untagged port list at the prompt. You can
specify the ports individually (e.g., 2,5,11), as a range (e.g., 5-10),
or both (e.g., 3,7,11-15,17). To specify all ports on the switch, enter
ALL. To remove all untagged ports that are assigned to the VLAN
from the currently selected switch module, enter NONE.
Note
You cannot remove untagged ports directly from the Default_VLAN.
To remove an untagged port from the Default_VLAN, you must
assign it as an untagged port in another VLAN.
c.
If there are ports on other switches in the stack that you want to
add or remove from the VLAN, change switch modules by
performing Step 8. Otherwise, skip to Step 9.
8. To add or remove ports from a VLAN from different switch modules in
a stack, you must change switches by doing the following:
a. Type M to choose Select another module.
The prompt message is displayed:
Select Module ID: [1 to 8] ->
b. Enter the ID of the switch module you want to change to, and
press the Enter key.
c.
Go to Step 7 and add or remove ports.