Allied Telesis AT-S25 - Manual (Page 105)

AT-S25 Management Software User’s Guide
105
Configuring STP
This section contains the following procedures:
❑ Configuring a Bridge’s STP Settings on page 105
❑ Configuring a Port’s STP Settings on page 107
Configuring a
Bridge’s STP
Settings
This section contains the procedure for configuring a bridge’s STP
settings.
Caution
The default STP parameters are adequate for most networks.
Changing them without prior experience and an understanding of
how STP works might have a negative effect on your network. You
should consult the IEEE 802.1d standard before changing any of the
STP parameters.
1. From the Main Menu, type 3 to select Spanning Tree Menu.
The Spanning Tree Menu in Figure 35 on page 101 is displayed.
2. From the Spanning Tree Menu, type 2 to select Active Protocol Version.
The following prompt is displayed:
Enter new value (S-STP, R-RSTP):
3. Type S to select STP.
4. Type 3 to select STP Configuration.
The STP Menu in Figure 36 is displayed.
Figure 36 STP Menu