Allied Telesis AT-S25 - Manual (Page 48)

Section II: Local and Telnet Mangement
48
Resetting a Stack
To reset a stack, perform the following procedure:
1. From the Main Menu, type 4 to select Administration Menu.
The Administration Menu as shown in Figure 10 on page 43 is
displayed.
2. From the Administration Menu, type 9 to select Reset Switch.
The following prompt is displayed:
Do you want to proceed with the switch reboot?
[Yes/No] ->
3. Type Y to reset the switch or N to cancel this procedure.
The switch reloads its operating system, a task requiring a
minimum of 20 seconds to complete.
For information on this parameter setting, refer to Table 1 on
page 43.
Caution
The stack will not forward traffic while it is reloading its operating
software. Some data traffic may be lost.