Allied Telesis AT-S25 - Manual (Page 82)

Section II: Local and Telnet Mangement
82
Creating a Port Trunk
This section contains the procedure for creating a port trunk on the
switch. Be sure to review the guidelines in Port Trunking Overview on
page 78 before performing the procedure.
Caution
Do not connect the cables to the ports in a port trunk until after you
have configured the trunk with the management software.
Connecting the cables before configuring the software will create a
loop in your network topology, possibly resulting in broadcast
storms and poor network performance.
Creating a
10/100 Port
Trunk
To create a 10/100 port trunk, perform the following procedure:
1. From the Main Menu, type 1 to select Ports Menu.
2. From the Ports Menu, type 3 to select Port Trunking.
The Port Trunking menu in Figure 29 is displayed.
Figure 29 Port Trunking Menu
3. To create the port trunk on a switch in the stack other than the one
you are currently managing, type M.
The prompt message is displayed:
Select Module ID: [1 to 8] ->
4. Enter the ID of the module you wish to select, and press the Enter key.