Allied Telesis AT-S25 - Manual (Page 183)

AT-S25 Management Software User’s Guide
183
❑ To download a file using TFTP, perform the following procedure:
a. Type T and press the Enter key. The following prompt is
displayed:
TFTP Server IP address:
b. Enter the IP address of the TFTP server. The following prompt
is displayed:
Remote File Name:
c. Enter the directory path and file name of the new
management software image that you wish to download;
then press the Enter key.
Note
The image file must be stored on the TFTP server.
Once the filename has been specified, the download begins.
Downloading an AT-S25 image file can take several seconds.
If you are installing a new management image file, the switch
begins to initialize the software after it is installed, a process that
takes approximately one minute to complete. Once the
management software is initialized, the switch will automatically
reboot with the new image file.
When downloading a new management image file using TFTP,
this image file is downloaded onto the Master switch of a stack
first. Then, from the Master switch, it gets downloaded onto all the
Slave switches in the stack. Once this process is finished, the entire
stack will reboot with the new image file.
Note
Do not interrupt the initialization process. Do not reboot the switch.