Allied Telesis AT-S25 - Manual (Page 107)

AT-S25 Management Software User’s Guide
107
Configuring a
Port’s STP
Settings
To adjust a port’s STP parameters, perform the following procedure:
1. From the Spanning Tree Menu, type 2 to select Active Protocol Version.
The following prompt is displayed:
Enter new value (S-STP, R-RSTP):
2. Type S to select STP.
3. Type 3 to select STP Configuration.
The STP Menu in Figure 36 on page 105 is displayed.
4. From the STP Menu, type P to select STP Port Parameters.
The STP Port Parameters menu in Figure 37 is displayed.
Figure 37 STP Port Parameters Menu
5. From the STP Port Parameters window, type M if you wish to select a
module other than the one currently displayed.
The prompt message is displayed:
Select Module ID: [1 to 8] ->
6. Enter the ID of the module you wish to select, and press the Enter key.
7. From the STP Port Parameters window, type 1 to select Configure RSTP
Port Settings.
The following prompt is displayed:
Start Port to configure [1 - 24] ->
8. Enter the number of the port you wish to configure. To configure a
range of ports, enter the first port of the range. Press the Enter key.