Allied Telesis AT-S25 - Manual (Page 54)

Section II: Local and Telnet Mangement
54
Configuring SNMP Community Strings and Trap IP Addresses
To configure the SNMP community strings for the switch and to assign
up to four IP addresses of management stations to receive traps from
the switch, perform the following procedure:
1. From the Main Menu, type 5 to select System Config Menu.
The System Config Menu as shown in Figure 12 on page 52 is
displayed.
2. From the System Config Menu, type A to select Advanced
Configuration.
The Advanced Configuration menu in Figure 13 is displayed.
Figure 13 Advanced Configuration Menu