Allied Telesis AT-S25 - Manual (Page 204)

Section III: Web Browser Management
204
Pinging a Remote System
You could instruct the switch to ping a node on your network. This
procedure is useful in determining whether a valid link exists between
the switch and another device.
To ping a network device, perform the following procedure:
1. From the Home Page, select Monitoring.
The Monitoring window is displayed with the System menu
option selected by default.
2. If the System menu option is not selected, select it and then select the
Ping Client tab.
The window in Figure 79 is displayed.
Figure 79 Monitoring - Ping Client Window
3. Enter the IP address of the end node you wish the switch to ping.
4. Click OK.
The results of the ping are displayed in a new window.
5. To stop the pinging, click OK in the pinging window.