Allied Telesis AT-S25 - Manual (Page 263)

AT-S25 Management Software User’s Guide
263
Configuring CoS
To configure CoS, perform the following procedure:
1. From the Home page, select Configuration.
2. From the Configuration page, select Layer 2.
3. From the Layer 2 page, select the COS tab.
A graphical image of an AT-8316F or an AT-8324 Fast Ethernet
Switch is displayed.
4. Click the port where you wish to configure the CoS.
You could select only one port at a time. A selected port turns
white. (To deselect a port, click it again.)
5. Click Modify.
The COS Setting window in Figure 112 is displayed.
Figure 112 COS Setting Window
6. Click the Priority pull-down menu and select either the high or low
priority queue for the port. The default is the low priority queue.
7. Select the Override Priority check box if you are configuring a tagged
port and you wish the switch to ignore the priority tag in the tagged
frames entering the port.
The default for this parameter is No, meaning that the priority
level of tagged frames is determined by the priority level specified
in the frame itself.